Mercury 305 CID - Page 167

2E-12 - MIE MODELS - VELVET DRIVE TRANSMISSIONS 90-823225--1 1096
NOTE: Refer to the following for installations where
dual station length anchor studs are present but only
a single station cable has been installed.
a - Cable End Guide
b - Throttle Lever Stud
c - Washer and Locknut
d - Spacer
e - Cable Barrel
f - Anchor Stud
g - Washer
h - Washer and Locknut
22552
d
c
b
a
e
d
h
f
g
Dual Station
a - Cable End Guide
b - Throttle Lever Stud
c - Washer and Locknut
d - Spacer
e - Cable Barrel
f - Anchor Stud
g - Washer
h - Washer and Locknut
22553
d
c
b
a
e
h
f
g
Dual Station
(4) Place remote control throttle lever(s) in
the wide-open-throttle (W.O.T.) position.
Check to ensure that throttle shutters
(valves) are completely open.
(5) Return remote control throttle lever to idle
position and check to ensure that throttle
lever contacts idle speed adjustment
screw.
72583
a - Tang
b - Carburetor Body
c - Idle RPM Adjustment Screw
b
c
a
IDLE
W.O.T.
Weber 4 Barrel Carburetor Shown in
Idle Position
71159
b
a
a - Throttle Shaft Lever [Contacts (b) at W.O.T. Position]
b - Carburetor Body Casting
Weber 4 Barrel Carburetor Shown in
Wide-Open-Throttle Position