MIE MODELS - VELVET DRIVE TRANSMISSIONS - 2E-1390-823325--1 1096
70392
a - Throttle Lever [Contacts (b) In Idle Position]
b - Idle Speed Adjustment Screw
b
a
Weber 4 Barrel Carburetor Shown in
Idle Position
8. Connect any ground wires or accessories that
were disconnected from engine.
9. Connect battery cables to battery by FIRST con-
necting positive (+) battery cable end to positive
(+) battery terminal. Tighten clamp securely.
Then, connect negative (–) battery cable end to
negative (–) battery terminal. Tighten clamp se-
curely.
b
c
d
e
f
g
h
a
74109
Throttle Body Injection
a - Cable End Guide
b - Throttle Lever Stud
c - Locknut and Flat Washer - Tighten Until Nut Bottom
Out,Then Back Off One Half Turn
d - Throttle Lever
e - Throttle Bracket
f - Cable Barrel
g - Flat Washer and Locknut
h - Throttle Cable Anchor Stud
To Next Page
Loading...
