MIE MODELS - HURTH TRANSMISSION - 2F-990-823225--1 1096
b. Place remote control shift lever and transmis-
sion shift lever in neutral position.
c. Remove nuts and washers from shift cable
attaching studs.
d. Locate center of remote control and control
shift cable play (backlash) as follows:
(1) Check that remote control is in neutral po-
sition.
(2) Push in on control cable end with enough
pressure to remove play; mark position
(a) on tube.
(3) Pull out on control cable end with enough
effort to remove play; mark position (b) on
tube.
(4) Measure distance between marks (a) and
(b); mark position (c), half-way between
marks (a) and (b).
72603
b
c
a
c
e. Center cable-end play, then adjust cable bar-
rel to align holes in barrel and in cable end
guide with attaching points on transmission.
f. Temporarily install shift cable. Do not secure
at this time.
IMPORTANT: Transmission is “fully” in gear
when shift lever comes to a stop, in either direc-
tion.
g. Place remote control shift lever in forward
gear position. Check to ensure transmission
is fully in gear, as follows:
(1) Hold shift lever in position.
(2) Carefully slide shift cable off of anchor
points.
(3) Attempt to move shift lever further.
h. Place remote control shift lever in reverse
gear position and again check to ensure
transmission is fully in gear as follows:
(1) Hold shift lever in position.
(2) Carefully slide shift cable off of anchor
points.
(3) Attempt to move shift lever further.
i. If transmission shift lever will position proper-
ly in one gear, but not in the other, recheck
shift cable adjustment. If transmission shift le-
ver will not position properly in both gears,
move transmission shift lever stud (a), from
top hole (c) in shift lever, to bottom hole, and
recheck for proper positioning. If proper posi-
tioning is still not obtained, remote control
does not provide sufficient shift cable travel
and must be replaced.
50228
b
a
c
Typical Hurth Transmission Shown
a - Shift Lever Stud (in Bottom Hole, if Required)
b - Lever, in Neutral Detent, Must Be Approximately
10 Degrees Aft of Vertical
c - Shift Lever Top Hole
j. Install nut and washer to cable end guide
stud. Tighten until snug, then back off one full
turn.
k. Install nut and washer to cable barrel stud.
Tighten until they bottom out. Tighten secure-
ly, but DO NOT OVER-TIGHTEN.
To Next Page
Loading...
