2F-12 –MIE MODELS - HURTH TRANSMISSION 90-823225--1 1096
(4) Place remote control throttle lever(s) in
the wide-open-throttle (W.O.T.) position.
Check to ensure that throttle shutters
(valves) are completely open.
(5) Return remote control throttle lever to idle
position and check to ensure that throttle
lever contacts idle speed adjustment
screw.
71159
b
a
a - Throttle Shaft Lever [Contacts (b) at W.O.T. Position]
b - Carburetor Body Casting
Wide-Open-Throttle Position Shown
70392
b
a
a - Throttle Lever [Contacts (b) In Idle Position]
b - Idle Speed Adjustment Screw
Idle Position Shown
b
c
d
e
f
g
h
a
74109
Throttle Body Injection
a - Cable End Guide
b - Throttle Lever Stud
c - Locknut and Flat Washer - Tighten Until Nut Bottom
Out,Then Back Off One Half Turn
d - Throttle Lever
e - Throttle Bracket
f - Cable Barrel
g - Flat Washer and Locknut
h - Throttle Cable Anchor Stud
7. Connect any ground wires or accessories that
were disconnected from engine.
8. Connect battery cables to battery by FIRST con-
necting positive (+) battery cable end to positive
(+) battery terminal. Tighten clamp securely.
Then, connect negative (–) battery cable end to
negative (–) battery terminal. Tighten clamp se-
curely.
To Next Page
Loading...
