90-823225--1 1096 WEBER 4 BARREL CARBURETOR - 5D-35
23. Ensure gasket is properly positioned between
the two parts and secure the top to bottom with
screws (nine total). Tighten securely.
70398
a
a - Screw(s)
24. Install metering rod springs into each metering
rod hole. Be certain to install the appropriate col-
or spring (refer to “Specifications”).
70397
a
a - Spring(s)
IMPORTANT: If using existing metering rods, be
sure that they are reinstalled in the same side
from which removed during disassembly.
25. Carefully install metering rod assemblies in the
appropriate holes. Push down lightly on metering
rods to ensure that
plunger will spring up and
down.
70396
a
a - Metering Rod Assembly(s)
IMPORTANT: Some carburetors are equipped
with air deflectors that are attached to the screw
that holds down the metering rod covers. Be sure
to reinstall the deflectors if your model carbure-
tor requires them.
26. Position metering rod covers (and air deflectors,
if equipped) over metering rods and install
screws. Tighten securely.
71094
71095
b
a
c
a - Screws
b - Metering Cover(s)
c - Air Deflectors (If Equipped)
To Next Page
Loading...
