HURTH DOWN ANGLE TRANSMISSION - 8C-590-823225--1 1096
2. Place remote control shift lever, and transmission
shift lever, in neutral position.
3. Remove nuts and washers from shift cable at-
taching studs.
4. Locate center of remote control and control shift
cable play (backlash), as follows:
a. Check that remote control is in neutral posi-
tion.
b. Push in on control cable end with enough
pressure to remove play, and mark position
(a) on tube.
c. Pull out on control cable end with enough ef-
fort to remove play, and mark position (b) on
tube.
d. Measure distance between marks (a) and (b),
and mark position (c), halfway between
marks (a) and (b).
72603
b
c
a
c
5. Center cable-end play, then adjust cable barrel to
align holes in barrel and in cable end guide with
attaching points on transmission.
6. Temporarily install shift cable. Do not secure at
this time.
IMPORTANT: Transmission is fully in gear when
shift lever comes to a stop, in either direction.
7. Place remote control shift lever in forward gear
position. Check to ensure transmission is fully in
gear, as follows:
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
8. Place remote control shift lever in reverse gear
position and again check to ensure transmission
is fully in gear as follows:
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
9. If transmission shift lever will position properly in
one gear, but not in the other, recheck shift cable
adjustment. If transmission shift lever will not po-
sition properly in both gears, move transmission
shift lever stud, from top hole in shift lever to bot-
tom hole, and recheck for proper positioning. If
proper positioning is still not obtained, remote
control does not provide sufficient shift cable
travel and must be replaced.
50228
b
c
a
a - Shift Lever Stud (In Bottom Hole, If Required)
b - Lever In Neutral Position, Must Be Approximately 10 De-
grees Aft Of Vertical
c - Shift Lever Top Hole
To Next Page
Loading...
