8C-30 - HURTH DOWN ANGLE TRANSMISSION 90-823225--1 1096
3. Reinstall piston rings on input shaft. Ensure ends
of rings are coupled as shown. Then position
rings so that ends are staggered so no two are
aligned.
27679
INTERMEDIATE SHAFT
!
WARNING
Do not touch bearing once it has been heated. Se-
vere burns could result. Use special protective
gloves to handle bearing.
1. Heat inner race of tapered roller bearing using a
torch lamp and press bearing onto shaft. When
bearing has cooled (DO NOT cool with water),
carefully tap bearing to ensure proper seating
against gear, using a soft (copper) punch. Tap on
inner race only.
71045
2. Install tapered roller bearing on opposite end of
shaft in the same manner.
OUTPUT SHAFT
!
WARNING
Do not touch bearing once it has been heated. Se-
vere burns could result. Use special protective
gloves to handle bearing.
1. Heat inner race of tapered roller bearing using a
torch lamp and press bearing onto shaft. When
bearing has cooled (DO NOT cool with water),
drive bearing down against gear using a soft
(copper) punch. Tap on inner race only.
71046
2. Install tapered roller bearing on opposite end of
shaft in the same manner.
NOTE: Tap bearing on splined end of shaft until it is
seated against shoulder on shaft.
To Next Page
Loading...
