HURTH DOWN ANGLE TRANSMISSION - 8C-3190-823225--1 1096
PREASSEMBLY OF OUTPUT HALF OF
HOUSING
IMPORTANT: If tapered roller bearing cups were
removed, ensure output shaft seal IS NOT in
place, as it will be necessary to heat housing
prior to installing bearing cups.
IMPORTANT: The tapered roller bearing cup on
the input shaft (control block end) is properly po-
sitioned by bottoming out on the face of the con-
trol block assembly. It will be necessary to tem-
porarily install control block to install this
tapered roller bearing cup.
1. Temporarily install control block on outer hous-
ing. Tighten bolts securely.
27682
27666
b
a
a
a - Input Shaft Bearing Cup
b - Control Block Face
!
WARNING
Use care in handling housing once it has been
heated. Severe burns could result. Use special
protective gloves to handle housing.
2. Heat bearing bores of housing using a torch lamp
and install bearing cups using a suitable man-
drel.
27681
b
a
a - Bearing Cups
b - Torch Lamp
3. Allow housing to cool (DO NOT cool with water)
and then tap bearing cup with suitable mandrel to
ensure it is properly seated.
4. Remove control block assembly.
To Next Page
Loading...
