HURTH DOWN ANGLE TRANSMISSION - 8C-3590-823225--1 1096
4. Install input half of housing onto output half. En-
sure locator pins are in place. Install bolts and
lockwashers and torque to 36 lb. ft. (49 N·m).
71064
Input Shaft Preload
1. Measure bearing clearance as follows:
a. Install special tool as shown. Tighten
hold-down bolts securely.
27863
b
a
a - Special Tool
b - Hold Down Bolts
b. Mount dial indicator on input shaft. Turn input
shaft several times to seat bearing.
27685
c. Zero the dial indicator.
27685
IMPORTANT: The following step should be done
very carefully to obtain the actual bearing clear-
ance. Avoid bumping the input shaft and turn
very slowly on the special tool knob. (Shaft will
only be moving a very small amount.)
To Next Page
Loading...
