8C-36 - HURTH DOWN ANGLE TRANSMISSION 90-823225--1 1096
d. Slowly turn the special tool knob clockwise to
push the shaft upward. (Perform the above
sequence several times to ensure an accu-
rate reading.)
27682
e. Make note of reading. The bearing clearance
measured PLUS the preload required is
equal to the amount of shim thickness to be
ADDED.
27685
Example:
Bearing Clearance Measured .009 in.
+ Bearing Preload Required .004 in.
= Shims to Be Added .013 in.
To Next Page
Loading...
