8C-42 - HURTH DOWN ANGLE TRANSMISSION 90-823225--1 1096
CONTROL BLOCK
1. Ensure piston rings are in place and the key is in
keyway. Align key on shaft with keyway in control
block.
2. Install new gasket between control block and
housing.
27666
b
a
a - Key
b - Piston Rings
3. Carefully push control block onto input shaft.
4. Coat each hex socket head bolt with a drop of
Quicksilver Loctite 8831. Secure control block to
housing with bolts and lockwashers. Torque to 18
lb. ft. (25 N·m).
27661
a
a - Hex Socket Head Bolts (6)
FLUID FILTER
1. Coat new O-rings with ATF.
50975
a
a - O-Rings
2. Reassemble filter assembly as shown. DO NOT
tighten and compress upper O-ring.
72805
a
a - O-Rings
To Next Page
Loading...
