Minebea Intec X3 - Switching on the device

Press the following keys one after the other:
-
SEtuP appears on the display.
-
/
bIoS appears on the display.
- /OK
bIoS... appears on the display.
FLASH follows on the display.
-
/
boot appears on the display.
- /OK
Restarting has the following effects on the device:
- Current process steps are deleted.
- The device is reset to its factory settings.
- The network settings are not changed.
7.2 Switching on the device
The device can be set up as follows:
- Via keys on the front of the device
- Via a notebook/PC using the VNC software (included on the CD)
- Via a notebook/PC using an Internet browser
When the device is powered up, the following is shown on the display:
Pr5410 The instrument type is displayed, PR 5410
b 1.00.00. BIOS version
F 1.00.00. Firmware version
Automatic display test
Weight display
X3 Process Indicator PR 5410 7 Getting started
EN-124 Minebea Intec