Minebea Intec X3 - Xbpi-Parameter Tables

— Ambient conditions
— Very stable cond.
— Stable conditions
— Unstable cond.
— Very unstable cond.
— Application/Filter
— standard mode
— manual filling
— automatic dosing
— checkweighing
— Stability range
— 0.25 digit
— 0.5 digit
— 1 digit
— 2 digits
— 4 digits
— 8 digits
— Stability symb.delay
— no delay
— short delay
— long delay
— extrem long delay
— Tare parameter
— at any time
— not until stable
— Auto zero function
— Auto Zero on
— Auto Zero off
— Adjustment function
— ext.adj.w.fact.wt.
— ext.adj.w.user.wt.
The parameters are listed as an overview in the following, see Chapter 7.15.5.3.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
7.15.5 xBPI-parameter tables
The parameters which must be entered are listed in the following tables under [Weighing
point]- [Weighing point A]- [xBPI-Scale]- [Setup]- [Configuration]- [Weighing
parameters]/[Application settings]/[Interface settings].
7.15.5.1 Scale parameters
[Weighing parameters]
18. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
19. Press the [Yes] softkey to save the data.
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-191