Minebea Intec X3 User Manual

9.5.2 Updating via a point-to-point connection with DHCP service
Requirements:
- Device and notebook/PC are connected to each other.
- The automatic address assignment "DHCP" is activated in the device and in the
notebook/PC; see Chapter 7.18.6.
- The "FlashIt!32" program (in a directory on the enclosed CD-ROM) is installed on the
notebook/PC.
- The "FlashIt!32" program is started.
9.5.2.1 Operations at the device
WARNING
Working on the device while it is switched on may have life-threatening
consequences.
Product operation must be performed by trained and qualified personnel who are
aware of and able to deal with the related hazards and take suitable measures for
self-protection.
1. Press .
SEtuP appears on the display.
2. Press .
bIoS appears on the display.
3. Press OK.
FLASH follows on the display.
bIoS... appears on the display.
4. Press OK.
EtHEr appears on the display.
5. Press OK.
The device waits for address assignment by the server.
172.024. The more significant part of the IP address is displayed for approx.
2 seconds.
dHCP... appears on the display.
6. Make sure to note down the digit sequence, because it must be entered into the
"FlashIt!32" window subsequently.
X3 Process Indicator PR 5410 9 Extended functions
EN-306 Minebea Intec

Minebea Intec X3 Specifications

General

Brand	Minebea Intec
Model	X3
Category	Measuring Instruments
Language	English