Minebea Intec X3 - Setting the Date and Time

Error6 Error message, if no sense voltage is connected, see also
Chapter 16.1.
Error9 Error message: if there is no communication with the xB-
PI scale (see also Chapter 16.2).
Error message: unable to read weight values from the
ADU (analog-digital converter); see also Chapter 16.1.
The weight display is shown.
Check the date and time after first turning on the device, see Chapter 7.2.1.
7.2.1 Setting the date and time
Entering the date and time via Notebook/PC (VNC/WEB browser)
See Chapter
7.18.2.
Entering the date and time using the front-panel keys
1. Press
.
SEtuP appears on the display.
2. Press "OK."
Cd 000 appears on the display ("Cd" flashes).
3. Press repeatedly (9×) until "dt 086" appears.
4. Press "OK."
YEAr appears on the display.
5. Press "OK."
2007 (YYYY) is displayed.
6. Use / and / to make changes accordingly.
7. Press "OK."
dAtE appears on the display.
8. Press "OK."
05/15 (MM/DD) appears on the display.
9. Use / and / to make changes accordingly.
10. Press "OK."
tIME appears on the display.
11. Press "OK."
17.35 (SS.MM) appears on the display.
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-125