7.14.14 Cancelling a calibration
Quit calibration by pressing the softkey.
You are prompted to confirm whether calibration should be closed without determining
the test value.
If not all data was determined when calibrating with [New] (e.g.dead load not set/
entered), this message is shown:
Press [Yes] to confirm and then press again the softkey, another prompt is displayed:
If you press [Undo], changes are not saved and the display returns to the selection menu
for the weighing points.
Leaving the menu is displayed by "Exit calibration".
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-179
To Next Page
Loading...
