Minebea Intec X3 - Date & Time; Operating Parameters; Printing Parameter

— xBPI-Port Selection: <none>, built-in RS-232
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— Date Date
Input: yyyy, mm, dd
— Time Time
Input: hh, mm, ss
— Application Selection: Standard, EasyFill
— Address Device address, e.g.for printing
Input: A…Z
— PIN Entry code with which to protect the system
control from unauthorized use.
Input: 6 numerical characters
— Use Alibi memory Select which values should be written in the
Alibi memory.
Selection: <none>; Gross; Net; Gross, Net, Tare;
Gross, Net; Gross, Tare
— Sequence number Automatic counter for individual print jobs
— SetTareKey Tare key
Selection: Tare&reset tare, tare&tare again,
disabled
— SetZeroKey Set zero key
Select: only when not tared, reset tare on
zeroset, disabled.
— N-G-T-Key Net - gross - tare - front key turn on/off
Select: disabled, enabled.
— PrintKey Print front key turn on/off
Select: disabled, enabled.
— TestKey Test front key turn off/on
Select: disabled, enabled.
— Print mode Print mode
Selection: <Print selected items>, via Nice Lable
(configure printout with Nice Label Express
(NLE).)
— 1. …6. Item Print layout for line 1…6; see Chapter 7.18.4.
7.13.2 Date & time
7.13.3 Operating parameters
7.13.4 Printing parameter
Note:
This menu item is only available if under
-[Operating parameter]- [Application]
"Standard" has been selected.
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-153