2 Safety instructions
2.1 General notes
CAUTION
Warning of personal injury.
This device has been built and tested in compliance with the safety regulations for
measuring and control equipment for protection class I (protective grounding
conductor) according to IEC 1010/EN 61010 or VDE 0411.
The device was in perfect condition with regard to safety features when it left the
factory.
To maintain this condition and to ensure safe operation, the user must follow the
instructions and observe the warnings in this manual.
2.2 Intended use
The device is intended for use of the analysis device for weighing functions.
Product operation, commissioning and maintenance must be performed by trained and
qualified personnel who are aware of and able to deal with the related hazards and take
suitable measures for self-protection.
The device reflects the state of the art.
The manufacturer does not accept any liability for damage caused by third-party system
components or due to incorrect use of the product. The use of this product signifies
recognition of the stipulations listed above.
Only for PR 5410/04
PR 5410/04 is designed for use in the USA and Canada and has UL approval.
The device is not compliant with directives that allow CE marking and also does not have
OIML approval.
2.3 Initial inspection
Check the contents of the consignment for completeness. Check the contents visually to
determine whether any damage has occurred during transport. If there are grounds for
rejection of the goods, a claim must be filed with the carrier immediately. The
Minebea Intec sales or service organization must also be notified.
2.4 Before operational startup
NOTICE
Perform visual inspection.
Before operational startup as well as after storage or transport, inspect the device
visually for signs of mechanical damage.
2 Safety instructions X3 Process Indicator PR 5410
Minebea Intec EN-11
To Next Page
Loading...
