Minebea Intec X3 - Showing Hardware Options

7.19.3 Showing hardware options
1. Select [Show HW-slots] and confirm.
1st line
Standard interface, serial
2nd line
In this case: Slot 1, not in use
3rd line
In this case: Slot 2, analog inputs and outputs
4th line
Standard interface, digital I/Os
5th line
In this case: Slot 4, ProfiBus-DP interface
The tool tip displays the version number.
6th line
Standard interface, weighing electronics
The tool tip displays the weighing point serial number and manufacturing date of
the factory.
This line shows the following device statuses:
X3 Process Indicator PR 5410 7 Getting started
EN-262 Minebea Intec