Minebea Intec X3 - Network Parameters

Note:
See Chapter 12.2
Example:
The gross weight should be read.
I/O size = 8 bytes, counted from byte 0–7
7.18.5.4 EtherNet-IP settings for Rockwell workstation
Requirements:
- PR 1721/37 DeviceNet EtherNet-IP is installed.
Procedure:
Note:
See Chapter 12.2
Example:
The gross weight should be read.
I/O size = 8 bytes, counted from byte 0–7
7.18.6 Network parameters
Under this menu item, you can define the network parameters for the network
connections (built-in LAN adapter).
Open the menu via
- [Network parameter].
[HW address]
This parameter cannot be changed because the fixed address is specified by the
instrument.
4. Assign the instrument name to the PR 5410.
1. Enter the IP address and network mask under
- [Fieldbus parameter] and
confirm.
2. Register the file "sag_5410_Ethernetip.eds" using the "Hardware Installation Tool".
3. Select and insert the instrument from the catalog into the I/O configuration.
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-243