4.6.6 Analog inputs and outputs
The interface card has the type designation PR 5510/07.
The plug-in card has one active analog output and 4 analog inputs. The analog inputs are
not supported by the standard device.
Only one PR 5510/07 card can be plugged into "Slot 1" or "Slot 2".
The analog inputs must be configured via the switch "S201" or "S202" after the
installation on the card.
Analog inputs
PIN 2 9 3 10 4 11 5 12
4 channels +CH1 GND +CH2 GND +CH3 GND +CH4 GND
Analog output
PIN 13 14
1 channel +0/4…20 mA Sig GND
Note:
For more information, see Chapter
4.6.1.
X3 Process Indicator PR 5410 4 Device installation
EN-78 Minebea Intec
To Next Page
Loading...
