Minebea Intec X3 - Selecting the Calibration Mode

7.14.3 Selecting the calibration mode
Note:
The [Modify] menu item is only used for small changes (e.g.changing the dead load/
preload, changing the mV/V values for dead load/preload and/or Max, changing the
scale interval). Otherwise select the [New] menu item.
Under - [Weighing point] - [Calib] choose between [New] and [Modify].
7.14.3.1 Performing a new calibration
1. Select -[Weighing point]- [Calib] and confirm.
2. Press the [New] softkey.
A prompt window opens.
X3 Process Indicator PR 5410 7 Getting started
EN-166 Minebea Intec