Minebea Intec X3 - Updating with a Fixed IP Address

9.5.2.2 Loading the software on your notebook/PC
9.5.3 Updating with a fixed IP address
Requirements:
- Device and notebook/PC are connected to a network/each other.
- The automatic address assignment "DHCP" is deactivated in the device and in the
notebook/PC, see Chapter 7.18.6.
- Notebook/PC is set to a fixed IP address.
021.081. The less significant part of the IP address is displayed for approx. 2
seconds.
7. Make sure to note down the digit sequence, because it must be entered into the
"FlashIt!32" window subsequently.
Now the device is ready to load the software.
FLASH? appears on the display.
1. Click the relevant file in the "Explorer" with the mouse and drag it into the [Select]
window, (or use 'Copy and paste').
2. Under [COM-Port] select "Network" and enter the devices IP addresses.
3. Click [Flash] to start the procedure.
As soon as software loading is completed the device will be re-started.
4. Load next file, as described.
9 Extended functions X3 Process Indicator PR 5410
Minebea Intec EN-307