Minebea Intec X3 - Opto-Decoupled Inputs and Outputs

Mode 4: Continuous single-bit output (23xDA), DATA_IN (1xDE)
Continuous output of bits, provided continuously without request (1xIN, 23xOUT, confi-
gurable).
- The driver modules are always "enabled."
- PIN 25 (DATA_IN) is an input.
Mode 5: Continuous single-bit output (24xDA), no DATA_IN
Continuous output of bits, provided continuously without request (24xOUT, configurab-
le).
- The driver modules are always "enabled."
- PIN 25 (DATA_IN) is an output.
4.6.11 Opto-decoupled inputs and outputs
This interface card has the type designation PR 5510/12.
The card converts the external binary signals from the process into the internal signal
level and vice versa. Inputs and outputs are each bipolar potential-free.
The plug-in card has 6 passive opto-decoupled inputs and 12 passive opto-decoupled
outputs. An external power supply is required.
The input signal is logically "0" when the input is open.
4 Device installation X3 Process Indicator PR 5410
Minebea Intec EN-91