Minebea Intec X3 - Selecting and Configuring RS-485 Interface

The available interfaces are visible under -[Show HW-slots].
7.16.2 Selecting and configuring RS-485 interface
Note:
The PR 5510/04 interface card must be installed in the device (see Chapter 4.6).
1. Select -[Serial ports parameter]- [xBPI-Port] and confirm.
The following window opens:
2. Select the desired interface and confirm.
3. Press the [Param] softkey.
The following window opens:
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-201