— Printer Printer
Selection: <none>, built-in RS232
— Param Selection: Assigned to, protocol, Baudrate, Bits,
Parity, Stopbits, Output mode
— Config See Menu [Printing parameter].
— Remote display Remote display
Selection: <none>, built-in RS-232
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits, Mode
— ModBus RTU Selection: <none>, built-in RS-232
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stop bits, Slave-ID
— SMA Selection: <none>, built-in RS-232
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— EW-Com Selection: <none>, built-in RS-232
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits, Slave-ID
The web menu is displayed.
For description of the web menu see Chapter 9.2.1.
NOTICE
If the VNC viewer is closed on the setup level, the device reboots and the web menu
is not accessible for several seconds.
If the web menu and the device view are required, the [Remote Configuration (VNC)
Pop-up Window] menu item must be selected in order for 2 windows to be opened
with the VNC viewer always remaining open, even if individual menu items are
selected in the web menu.
7.13 System setup
7.13.1 Serial ports parameter
X3 Process Indicator PR 5410 7 Getting started
EN-152 Minebea Intec
To Next Page
Loading...
