Note:
The SPM address %MX for an unused digital output = 0.
8.4.3 Configuring material
The materials (products) 1…10 are configured under the [Configuration material] menu
item.
The following window opens:
6. Select outputs 1…3. Use the keypad to enter and confirm a corresponding SPM
address %MXxxx (see Chapter
13.4).
7. Press to exit the window and to save the changes.
1. Select [Configuration material] and confirm.
8 Production X3 Process Indicator PR 5410
Minebea Intec EN-281
To Next Page
Loading...
