Note:
Some xBPI platforms have what is known as "specification blocks" for selecting
various modes of operation (single range, multiple range, etc.).
The following is required for the subsequent specification group selection:
- Note the model name of the scale.
- Refer to the operating instructions for the number of the corresponding
specification block.
Press [No] for exit from the menu without data change.
The parameters are listed as an overview in the following, see Chapter 7.15.5.1.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
The parameters are listed as an overview in the following, see Chapter 7.15.5.2.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
6. Select [Select group of specification] using the cursor and confirm.
7. Select and confirm the desired specification group.
8. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
9. Press the [Yes] softkey to save the data.
The parameters are saved. Ticks indicate the progress.
10. Select [Configuration] using the cursor and confirm.
11. Select [Weighing parameters] with the cursor and confirm.
12. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
13. Press the [Yes] softkey to save the data.
14. Select [Application settings] with the cursor and confirm.
15. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
16. Press the [Yes] softkey to save the data.
17. Select [Interface settings] with the cursor and confirm.
X3 Process Indicator PR 5410 7 Getting started
EN-190 Minebea Intec
To Next Page
Loading...
