— Number of
vessel feet
Load cells Inteco®/..: Enter number.
— Local gravity Enter local gravity (standard: Hamburg
9.81379 m/s
2
)
— Max Enter maximum load:
0.000010…<3000>…9999998 <kg>, t, lb, g,
mg, oz
— Scale interval Enter scale interval (1 d): <1>, 2, 5, 10, 20, 50
displayed according to the decimal places at
Max and the weight unit.
— Dead load Dead load: Weight of the empty scale
— CAL weight Enter calibration weight: 0.000010…9999998
<kg>, t, lb, g, mg, oz
— Corner
correction
Platform 1, platform 2 (only appears when the
number of load cells = 8).
OK, when carried out.
— Modify Only used for minor changes (e.g. changing the
dead load). Otherwise, always use [New]!
— Param Parameter settings
— Measuretime Measurement time: The value cannot be
changed. It is specified by the Connexx module.
— Digital filter Selection of the digital filter (filter
characteristic): <off> (no filter), Bessel, aperiod.
(aperiodic), Butterw. (Butterworth), Tcheby.
(Tschebyscheff)
— Fcut Only if filter is not "off", enter the corner
frequency: 0.1–80.0 Hz
— W&M Select legal-for-trade mode: <none>, OIML,
NSC, NTEP
— Unbal.
Check deviat.
Unbalanced check deviation: the plausibility
check is activated when the average deviation
is >0%.
Entry: 0…100 %
— Standstill time Enter the standstill time: 0.01 s…<0.50 s>…2.0 s
(range depends on the measurement time).
— Standstill
range
Enter the standstill range:
0.00 d…<1.00 d>…10.00 d (range depends on
the measurement time).
— Tare timeout Enter the timeout when there is no standstill:
0.1 s…<2.5 s>…25 s
— Zeroset range ± Range of zero point when there is no
standstill. Input:
0.00 d…<50.00 d>…10000.00 d
— Zerotrack
indic. range
Enter the zerotrack indication range:
0.00 d…<0.25 d>…10000.00 d
— Zerotrack step Enter the zerotrack steps:
0.00 d…<0.25 d>…10.00 d
— Zerotrack time Enter the zerotrack time interval: <0.0 s>…25 s
— Overload Enter the weighing range above the maximum
capacity (Max), without error message:
0…<9 d>…999999 d
7 Getting started X3 Process Indicator PR 5410
Minebea Intec EN-161
To Next Page
Loading...
