Minebea Intec X3 User Manual

SPM address Data type R/W Function
B18 SINT R Verification interval (for multi-interval/multi-range = d1 or e1)
B19 BYTE R Last weighing point error, see Chapter 16.6.1.
B20 BYTE R Higher byte of product code (0x54)
B21 BYTE R Lower byte of product code (0x10)
B22 BYTE R Major part of version number (1.0)
B23 BYTE R Minor part of version number (1.0)
D6 UDINT R Serial number (board number)
W14 INT R Counter will be increased for every measured value.
D8 DINT R Current gross weight
D9 DINT R Current net weight
D10 DINT R Current tare weight
D11 DINT R Current gross/net weight selected with X72
D14 DINT R Max weight (FSD = Full Scale Deflection)
D15 DINT R Min weight
D16 DINT R Report: Gross weight
D17 DINT R Report: Net weight
D18 DINT R Report: Tare weight
D19 DINT R Report: Sequence number
D20 DINT R Application-independent: Flow value (weight change•100/minute)
if no BCD card is installed.
Standard only: BCD value for "transparent" mode
D21 DINT R Report: Date
D22 DINT R Report: Time, BCD display
D23 DINT R Activity counter, test of communication with device
D24 DINT R Standard only: Limit: Limit 1 on
D25 DINT R Standard only: Limit: Limit 1 off
D26 DINT R Standard only: Limit: Limit 2 on
D27 DINT R Standard only: Limit: Limit 2 off
D28 DINT R Standard only: Limit: Limit 3 on
D29 DINT R Standard only: Limit: Limit 3 off
D30 UDINT R/W Standard only: Analog output for "transparent" mode
D31 DINT R/W Preset tare memory (X118, X119)
X3 Process Indicator PR 5410 13 SPM
EN-338 Minebea Intec

Minebea Intec X3 Specifications

General

Brand	Minebea Intec
Model	X3
Category	Measuring Instruments
Language	English