You could also load an effect preset from the Browser instead of using the Plug-in menu. For more
information on how to load effect presets, see ↑4.2, Searching and Loading Files from the Library.
Now that the effect is loaded, we suggest that you rename the Sound slot to the Plug-in name:
this will be of great help when routing other signals to that send effect (see section ↑14.3.2,
Step 2: Route Audio to the Send Effect below). To rename the Sound slot:
1. Double-click the name of the Sound slot in the Sound List.
The name becomes highlighted, ready to be edited.
2. Type the name of the Plug-in, and press [Enter] on your computer keyboard to confirm.
→ The Sound slot now mirrors the Plug-in name.
For more information on renaming Sound slots, see section ↑5.2.3, Renaming Sound Slots.
Set Up a Sound as Send Effect on the Controller
First, select the first Plug-in slot of an empty Sound:
1. Press the CONTROL button to enter Control mode.
2. Press F3 to select the SOUND tab.
3. Press GROUP + the pad 9–16 corresponding to the Group containing the empty Sound
you want to use. If the Group in question is in another bank, before you select the Group
you first need to press GROUP + the Left or Right Arrow button below the display to
switch to the Group bank containing that Group.
4. Press SELECT + the unlit pad of the empty Sound you want to use (or simply hit its unlit
pad if pads are in Pad Mode).
Using Effects
Creating a Send Effect
MASCHINE MIKRO - Manual - 658
To Next Page
Loading...
Need help?
General
Weight and Dimensions
