2. Press F2 to select WAVE.
3. Press pad 2/6 to zoom in on the waveform of the Sample and pad 1/3 to scroll through it.
4. When you are done, don’t forget to press the lit VIEW button again to leave View mode
and switch back to Sampling mode.
The waveform provides the following additional information:
▪ Above the waveform, the information bar indicates the name and length of the Sample.
▪ The Sample can be played back at any time by pressing the corresponding pad on your
controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.
▪ The grayed out and highlighted parts on the waveform indicate you where the play and se-
lection ranges are located (see details below).
The parameters available at the bottom of the display are spread over two pages:
1. Press NAV + Left/Right Arrow button to access the desired page of parameters.
2. Press the Left/Right Arrow buttons to select the parameters within each page.
3. To adjust the selected parameter, turn the Control encoder. For continuous parameters,
press and turn the Control encoder to adjust the value in finer increments.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE page allow you to adjust the range that will be played
when you trigger a note.
The EDIT page on the controller, page 1 of 2: adjusting the play range of the Sample.
Sampling and Sample Mapping
Editing a Sample
MASCHINE MIKRO - Manual - 839
To Next Page
Loading...
