NEC iPASOLINK EX Advanced - Page 175

3-30 SECURITY MANAGEMENT
GGS-000547-01E iPASOLINK EX Advanced: SET NETWORK AND SYSTEM PROVISIONING
5. Assign the appropriate value to each parameter:
Figure 3-27 NTP Setting Option Window
Table 3-16 NTP Setting Parameters
Parameter Value Description
NTP Enable Enable/Disable the NTP Protocol on the equipment.
Disable
NTP Server Mode Multicast Specify the NTP Server mode.
Unicast
Disabled
NTP Client Mode Multicast Specify NTP Client mode.
Unicast
Disabled
Stratum 2 to 15 Set Stratum level of the NTP Time Packets. The
lowest Stratum should be received in NTP PDU plus
1.
NTP Authentication Enable Enables the use of NTP Authentication.
Disable Disables the use of NTP Authentication.
Multicast Auth Key
Index
Not Used To assign the Auth Key Index, select the index number
from the drop-down list. Otherwise, select Not Used.
(available Auth Key Index #)
Multicast Port Bridge01 to Bridege06 Select a port to output the Multicast Time information.
This parameter is enabled when NTP Server Mode
selects Multicast.
Multicast Interval 16 to 131072s Select Multicast Interval. [unit: second]