EasyManua.ls Logo

NEC iPASOLINK EX Advanced - Eth-Oam Rdi; ETH-OAM Unexpected MEP

NEC iPASOLINK EX Advanced
793 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CORRECTIVE MAINTENANCE 5-29
iPASOLINK EX Advanced: OPERATION & MAINTENANCE GGS-000548-01E
BB
This condition indicates that the RDI (Remote Defect Indication) is detected from the
received ETH-CC Frame on the indicated MEP. The problem of this condition
pertains to alarms (failure) at the peer MEP.
Procedure 5-12
1. Check if any alarm is issued to an MEG of a peer MEP that is associated with the
indicated MEP.
2. Is there any alarm occurring?
YES: Contact NEC.
NO: Clear it/them, and go to Step 3.
3. Retrieve the Current Status, and check if the ETH-OAM RDI alarm is cleared. If
the alarm is not cleared, contact NEC for the further maintenance support.
This step ends the procedure.
BB
This condition indicates that a mismatch of ETH-CC transmit period is detected from
the indicated MEG. The problem is a mismatch between the MEG Configuration of
local NE and that of far-end NE in WebLCT.
Procedure 5-13
1. Check the MEG Configuration, and correct it if it has any error.
2. Retrieve the Current Status, and check if the ETH-OAM Unexpected MEP
alarm is cleared.
3. Is the ETH-OAM Unexpected MEP alarm cleared?
YES: This step ends the procedure.
NO: Check the MEG Configuration of the far-end NE, and go to Step 4.
4. Retrieve the Current Status, and check if the ETH-OAM Unexpected MEP
alarm is cleared. If the alarm is not cleared, contact NEC for the further
maintenance support.
This step ends the procedure.
ETH-OAM RDI
ETH-OAM Unexpected MEP

Table of Contents