MOUNT iPASOLINK EX/A 4-5
iPASOLINK EX Advanced:INSTALLATION GGS-000546-01E
4.3 Mount SFP Module
ATTENTION!!
For the purpose of the use in iPASOLINK EX/A, it is recommended to use the SFPs
that are designated and supplied by NEC. NEC will not guarantee the
performances of iPASOLINK EX/A if other vendors’ SFP modules are installed.
The Small Form-Pluggable (SFP) is a compact and hot-pluggable transceiver
designated to support 10 Gigabit Ethernet (10GbE) and/or 1 Gigabit Ethernet (GbE)
in the iPASOLINK EX/A. The SFP on iPASOLINK EX/A offers the following:
1) Single Module Fiber (SMF): This SFP complies with 10GBASE-LR Ethernet
and 1000BASE-LX Ethernet. The SFP operates with the 1310 nm laser
transmitter and has a duplex LC connector.
2) Multi Mode Fiber (MMF): This SFP complies with 10GBASE-SR and
1000BASE-SX Ethernet interfaces. The SFP operates with the 850 nm laser
transmitter and has a duplex LC connector.
3) Electrical SFP (RJ-45): This SFP complies with 10/100/1000 BASE-T copper
interface.
The SFP Modules also accept LC Fiber Connectors with polished connector (LC-PC)
or ultra polished connector (LC-UPC).
PORTS FOR SFPs
(SFPs are mounted.)
To Next Page
Loading...
