CONNECT CABLES 5-1
iPASOLINK EX Advanced: INSTALLATION GGS-000546-01E
5. CONNECT CABLES
5.1 Overview
This section provides the descriptions for connecting Traffic Cables and Power
Cable. This section also provides the assembly methods of the Grounding Cable and
Power cable for the purpose of preparing them on site if needed.
Following shows the summary of the cable installation:
1.
Connect the Grounding Cable to Grounding Terminal on iPASOLINK EX/A. (See
6. GROUND iPASOLINK EX/A for detailed descriptions and steps.)
NOTE: Tightening torque is 2.7 ±0.3 N•m
2. Connect the Power Cable.
NOTE: This step is not required when using a PoE. Go to Step 3.
3. Connect a LAN Cable to DCN (PoE) Port.
NOTE: To use this port as the PoE, confirm that the power injector to be
connected is powered off. If it is powered on, connecting the LAN
cable to DCN (PoE) port immediately turns on the iPASOLINK EX/A.
(1) Connect a LAN Cable to
DCN (PoE) Port on iPASOLINK EX/A.
(2) Connect the other end of LAN Cable:
To use this port as PoE, connect it to the power injector.
To operate WebLCT, connect it to your PC (web browser must be installed).
4. Connect LAN Cables to P2 and P3 Ports, as necessary.
To Next Page
Loading...
