Issue 1.2 UNIVERGE SV9100
3 - 52 Installing the SV9100 Chassis
securing it in place. Note that the cabling is run through the front of the rack
for ease of access.
5. Secure the brackets to the rack using the screws supplied.
Repeat for additional chassis mounting.
6. Connect the ground wire to all chassis. Refer to 1.1.3 Install Grounding on
19” Chassis on page 3-13 for complete details on grounding the system.
Each CHS2UG chassis will require approximately 3.5” of height
within the rack.
Figure 3-67 Rack Mount 19” CHS2UG
To Next Page
Loading...
