UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 45
Cord Groove (DT300).
3. Turn the terminal over and place it so the Line Cord can be
passed through the groove between the tilt legs. Refer to
Figure 5-34 Line Cord Groove Back of Terminal (DT300).
4.1.2.2 Line Cord Connection DT400
4. Install the modular plug of the Line Cord into the Line
Connector at the back of terminal. Push until it snaps into
place. Refer to Figure 5-35 Installing the Line Cord (DT400)
on page 5-46.
Figure 5-33 Line Cord Groove (DT300)
Figure 5-34 Line Cord Groove Back of Terminal (DT300)
To Next Page
Loading...
