UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 41
continue installation of the chassis or, Chapter 6 paragraph 2.1
Installation and Safety Precautions on page 4-3 for installation of
blades.
SECTION 4 STAND MOUNTING THE CHASSIS
4.1 Stand Mounting the 19” (CHS2UG) Chassis
A single or multiple chassis can be stand mounted. Controlling and Expansion
chassis can be stand mounted using the CHS2UG STAND KIT (K) and CHS2UG
STAND KIT (EXT).
4.1.1 CHS2UG Chassis Installation
1. Using the supplied screws, assemble the CHS2UG STAND KIT (K)
and CHS2UG STAND KIT (EXT) (refer to figure below).
2. Secure the CHS2UG chassis to the assembled CHS2UG STAND KIT
(K), see figure below.
Figure 3-53 Assemble Stand Mount with Screws
To Next Page
Loading...
