NEC Univerge SV9100 - Unmanaged Switch Functions; LED Indications; Connectors

Issue 1.2 UNIVERGE SV9100
4 - 104 Installing the SV9100 Blades
2. User removes Add-on board and moves it to slot 6.
 The re-inserted board automatically gets ports
17 ~ 24 (9 ~ 16 are unavailable).
. User can erase the ports 9 ~ 16.
. Then reinsert the board in slot 6 to get ports 9 ~ 16.
3. User relocates the Main board to slot 4.
 None of the port numbers change. However, the
programming in Program 10-55 must be changed to
reflect this move.
The grouping of the three GSWU units to form a 20 port
switch is restricted to reside in a single system location. The
grouping is not allowed where the GSWU units are placed
as part of the NetLink feature in the Univerge SV9100
system.
6.4.2.5 Unmanaged Switch Functions
In the unmanaged mode, a GSWU unit will have the
following functions only:
 10/100/1000 Ethernet ports (x8)
 PoE Class 3 (lowest power class)
6.4.3 LED Indications
6.4.4 Connectors
Backplane Connector – J1 connection to system CPU board and
other boards in the chassis.
Table 4-49 CD-ETIA LED Indications
Port State LED Display
1000Mbps Link Green Solid
10/100Mbps Link Yellow Solid
No Link Off
Port Activity LED Blinking