EasyManua.ls Logo

NEC Univerge SV9100 - Charging the Battery

NEC Univerge SV9100
478 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Issue 1.2 UNIVERGE SV9100
5 - 150 Installing DT Series Digital and IP Multiline Terminals
Figure 5-175 ML440 - Handset Charger
11.4 Charging the Battery
1. Install the handset battery as shown.
Figure 5-176 ML440 - Handset Battery Installation
Remove the battery cover
from the back of the handset.
Insert the bottom of the battery into
the compartment. Lay the battery
down and push it gently until it snaps
into place.
Replace the battery cover
and slide it up into place.

Table of Contents

Other manuals for NEC Univerge SV9100

Related product manuals