NEC Univerge SV9100

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 43
SECTION 4 INSTALL MULTILINE TERMINALS
4.1 Connecting the DT300/DT400 Series Multiline Terminal to the
System
This instruction applies to all DT300/DT400 Series Multiline Terminals.
4.1.1 Connecting the Handset
Confirm the location of the handset connector
on the bottom of the
multiline terminal. Then, connect the handset to the multiline terminal
using the steps shown below.
4.1.1.1 Handset Connection DT300
1. Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
2. Lead the Handset cable through the applicable groove. Refer
to Figure 5-30 Installing the Handset (DT300).
4.1.1.2 Handset Connection DT400
1. Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
2. Lead the Handset cable through the applicable groove. Refer
to Figure 5-31 Installing the Handset (DT400) on page 5-44.
Figure 5-30 Installing the Handset (DT300)