NEC Univerge SV9100 - Bluetooth Hub Adapter (BHA) Features; Installing the BHA-L UNIT

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 119
SECTION 8 BLUETOOTH HUB ADAPTER
8.1 Bluetooth Hub Adapter (BHA) Features
The BHA-L UNIT adapter connects a Bluetooth device to a DT300/DT400
multiline terminal. The BHA-L UNIT cannot be connected to the DTL-2E-1,
DTZ-2E-3, DTL-6DE-1 or DTZ-6DE-3 telephone.
8.1.1 Installing the BHA-L UNIT
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline
terminal.
. Only one BHA-L UNIT can be attached to the DTL multiline terminal.
3. Lower the tilt leg to the first position (refer to Figure 5-137
Separate Tilt Leg from Leg Support).
4. Remove the connector cover (rubber) from the bottom of the
multiline terminal (see Figure 5-138 Removing the Connector
Cover on page 5-120).
Figure 5-137 Separate Tilt Leg from Leg Support
Before installing or removing the BHA-L UNIT,
remove the line cord and the AC adapter from the
outlet.
Stoppers
Tilt Leg