NEC Univerge SV9100 - Applying Power to the DT700 Multiline Terminals

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 47
4.2 Applying Power to the DT700 Multiline Terminals
The DT700/DT800 terminals support two different methods to power the
terminal:
 AC-2R/AC-3R
Plug the optional AC-2R/AC-3R AC Adapter input Jack in the terminal
base unit, and plug the wall plug of the AC Adapter in a standard 230
Vac wall outlet.
 In-Line Power/PoE (Power over Ethernet)
In-Line Power (sometimes called Power Over Ethernet) is a LAN
technology that allows standard 10 Base-T/100 Base-TX data cables to
pass electrical current from a power source to a requesting end device.
Figure 5-1 Line Cord Groove Back of Terminal (DT400)