Issue 1.2 UNIVERGE SV9100
4 - 42 Installing the SV9100 Blades
4.3.2 Installation
Install the GCD-4LCA
/ GCD-8LCA blade into any available universal
slot.
. If the GPZ-4LCA/GPZ-8LCE is used, install this prior to inserting the
GCD-8LCA into the chassis
4.3.3 LED Indications
LED indications for the GCD-4LCA
/GCD-8LCA are listed in Table 4-
20 GCD-4LCA/GCD-8LCA LED Indications. Each LED is listed with
its associated function and LED and Operational status. Refer to
Figure 4-11 GCD-4LCA/GCD-8LCA Blade on page 4-40 for the
location of the LEDs on the blades.
When connecting a fax machine or analog
modem, make sure to set Program 15-03-03 to
1 (special terminal) to avoid communication
problems.
The SLIU and SLIDB are categorized as
TNV2. With this designation, off-premise
wiring is not acceptable. Any cabling to the
SLIU blade must be within the building – no
outside cabling is permitted.
Branch connection is not acceptable.
Table 4-20 GCD-4LCA/GCD-8LCA LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED
(Red)
On On System Initializing –
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software
version is not matched.
Flash (1s) Trouble found during self-diagnostics. –
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off All channels are idle. –
To Next Page
Loading...
