NEC Univerge SV9100 - Connector Pin-Out on the GPZ-BS10;GPZ-BS11; Install the GPZ-BS10 Expansion Base Blade in the CHS2 UG Controlling Chassis

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 5
1.1.2.1 Connector Pin-Out on the GPZ-BS10/GPZ-BS11
1.1.2.2 Install the GPZ-BS10 Expansion Base Blade in the
CHS2UG Controlling Chassis
1. Ensure the chassis is powered down.
2. Locate the door positioned on the left end (expansion bay) of
the Controlling Chassis (refer to Figure 3-7 GPZ-BS10
Expansion Bay in Controlling Chassis on page 3-6).
Table 3-1 GPZ-BS10/GPZ-BS11 Connector Pin-Out
RJ-61 Cable Connector
GPZ-BS10 –
CN2, CN3, CN 4
GPZ-BS11 – CN3
Pin No. Connection
1HW_UP (+)
2HW_UP (-)
3 HW_DWN (+)
4FS (+)
5FS (-)
6 HW_DWN (-)
7 CK8M (+)
8 CK8M (-)
Figure 3-6 GPZ-BS10 Components
Do not remove or install this blade with the
power on.