Issue 1.2 UNIVERGE SV9100
5 - 70 Installing DT Series Digital and IP Multiline Terminals
4.12 Wall Mounting the Multiline Terminal
You can wall mount a DT Series connection Multiline Terminal using the base
cover or an optional wall mount unit. A wall mount unit must be used if
adapters are installed on the Multiline Terminal.
4.12.1 Wall Mounting a Multiline Terminal using the Base Plate
4.12.1.1 Adjusting the Hanger Hook
1. Remove the hook from the unit.
2. Turn the hook with the tab toward the top.
3. Slide the hook until it glides into position forming the
hanger hook for the handset.
Figure 5-64 Removing the Hanger Hook on a DT
Series Terminal
Figure 5-65 Sliding the Hanger Hook into Position
To Next Page
Loading...
