NEC Univerge SV9100 - Wall Mounting the Bluetooth Cradle

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 115
7.4.2 Wall Mounting the Bluetooth Cradle
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can withstand the
weight of the telephone and the load from pulling the telephone
during operation.
1. Attach two wood screws to the wall.
. Keep a clearance of about 0.08” (2mm) between each wood screw
and the wall (refer to Figure 5-131 Installing Wood Screws on page
5-116).
Figure 5-130 Wall Mount Spacing Guide BCH-L (BK) UNIT
To prevent possible damage to the BCH-L (BK)
UNIT due to falling, NEC recommends installing
the unit in a firm position so it will not fall due to its
own weight.