Issue 1.2 UNIVERGE SV9100
5 - 48 Installing DT Series Digital and IP Multiline Terminals
4.3 Connecting the DT700/DT800 Series IP Multiline Terminal to the
Network and PC
These instructions for connecting an IP Multiline Terminal to the Network and
PC apply to DT700/DT800 series Multiline Terminals. Refer to Figure 5-37 IP
Terminal Connector Locations.
1. Connect the LAN Network
10Base-T/100Base-TX cable to the LAN (=)
connector.
2. The IP terminal has a switching HUB to connect a PC to the LAN
Network. Connect the 10 Base-T/100 Base-TX straight cable used for
this connection to the PC(x) connector and to the PC.
Refer to Figure 5-38 Typical Network IP Connection on page 5-49.
Figure 5-37 IP Terminal Connector Locations
To Next Page
Loading...
