UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 17
m Stand-mounted refer to 4.2 Stand Mounting the 9.5” CHS2UG B Chassis on
page 3-46.
From the factory, the SG, ETH and PBXG grounds are located inside the chassis
and are connected to the FG (frame ground) on the back of the chassis.
1.2.1 Install Grounding on 9.5” Chassis
1. Ensure the 9.5” chassis is powered off and the AC power cord is
unplugged.
2. Ground the chassis by connecting a 14 AWG wire from the FG lug on
the back side of the chassis to an electrical service ground (such as a
cold water pipe). Refer to Figure 3-27 9.5” Chassis (Rear View).
Figure 3-26 9.5” Chassis (Front View)
Figure 3-27 9.5” Chassis (Rear View)
To Next Page
Loading...
